Menu

MPLS

L2circuit for L2 protocol tunneling

4 October 2016

Remember that in the QinQ and L2PT on Junos ELS post we discussed how to configure QinQ and L2PT on EX4600 and how we saw that actually L2PT is not supported on EX4600. Well, in this post we will discuss about a workaround and that is to configure a L2 Circuit(EoMPLS in Cisco world). L2… Keep reading »

6PE over MPLS

5 December 2017

This post will explain how you can connect IPv6 domains over IPv4 MPLS enabled network using Juniper routers. First, a short introduction about 6PE. The 6PE(IPv6 Provider Edge routers) routers are dual stack to be able to run IPv6 to connect to the IPv6 islands and to connect to MPLS core which is IPv4. 6PE… Keep reading »

Sidebar